Safety Notes - Leuchtkraft DMX-3216 Bedienungsanleitung

25 Control FADE TIME / M-FADE to adjust the
crossfade time to be used while programs
are being called up, and to adjust the speed
of the movement while movement patterns
are being called up
26 DMX control signal output (3 poles, XLR) for
connection to the DMX input of a DMX light
effect unit;
Pin 1 = ground, 2 = DMX−, 3 = DMX+
27 USB port for connection of a USB storage
device to save user-defined programs (CHASE)
28 RCA jack AUDIO for connection to the output
of an audio source for the music control of
programs
When the jack is connected, the internal
microphone of the controller will be switched
off .
29 Jack MIDI OUT; will provide MIDI signals when
the controller is being operated
30 Jack MIDI THRU
The MIDI signals received at the jack MIDI IN
are available at this jack for further MIDI-con-
trolled units .
31 Jack MIDI IN, receives the MIDI signals for
controlling the controller
32 Jack DC INPUT for power supply via the mains
unit supplied
33 POWER switch
18

2 Safety Notes

The units (controller and power supply unit) cor-
respond to all relevant directives of the EU and
are therefore marked with
WARNING The power supply unit uses dan-
gerous mains voltage . Leave ser-
vicing to skilled personnel . Inex-
pert handling or modification may
result in electric shock .
•
The units are suitable for indoor use only . Pro-
tect them against dripping water, splash water
and high humidity . The admissible ambient
temperature range is 0 – 40 °C .
•
Do not operate the controller and immedi-
ately disconnect the power supply unit from
the socket
1 . if the units are visibly damaged,
2 . if a defect might have occurred after the
units were dropped or suffered a similar
accident,
3 . if malfunctions occur .
In any case the units must be repaired by skilled
personnel .
•
For cleaning only use a dry, soft cloth; never
use water or chemicals .
•
No guarantee claims for the units and no liability
for any resulting personal damage or material
damage will be accepted if the units are used
for other purposes than originally intended, if
they are not correctly connected or operated, or
if they are not repaired in an expert way . Like-
wise, no liability will be accepted for any data
loss resulting from a defect or from operating
errors and for any consequential damage that
is due to this data loss .
If the units are to be put out of oper-
ation definitively, take them to a local
recycling plant for a disposal which is
not harmful to the environment .
.