Preparations For Use; Connecting The Power Cord; Connecting The Foot Control; Connecting The Motor Handpiece - NSK VOLVERE i7 Bedienungsanleitung

5

Preparations for Use

5-1 Connecting the Power Cord

Align the shape of the Power Cord Plug with the inlet on the rear of the
Control Unit, and fully insert it (Fig. 1).
When disconnecting the Power Cord, firmly grip the Control Unit and the
Power Cord plug, then pull the plug straight out.

5-2 Connecting the Foot Control

Align the positioning of the Foot Control Cord Plug (the
Foot Control Cord Socket on the rear of the Control Unit, and fully insert it
(Fig. 2).
When disconnecting the Foot Control cord, firmly grip the Control Unit and
the Foot Control Cord Plug, then pull the plug straight out.

5-3 Connecting the Motor Handpiece

Align the positioning of the Motor Handpiece cord plug with the Motor
Cord Socket on the front of the Control Unit, and fully insert it (Fig. 3).
When disconnecting the Motor Handpiece cord, firmly grip the Control
Unit and the Motor Handpiece cord plug, then pull the plug straight out.
• When disconnecting a cord, make sure to grip it by the plug. Removing by pulling the cord may
CAUTION
cause it to break.
NOTICE
• This product can also be connected to motors for NSK VOLVERE Vmax (GX35RM & SCD, GX35M
& SCD).

5-4 Attaching / Removing the Handpiece

• Attach or disconnect the Handpiece only after the power has been turned OFF and the bur has
CAUTION
completely stopped rotating.
• After attaching the Handpiece, make sure the Handpiece is securely connected to the Motor.
Motor Handpiece (VOLVERE i7 RM)
Removing:
Turn the bur lock ring of the Handpiece from the LOCK position
further towards the LOCK direction (Fig. 4).
Attaching:
Turn the bur lock ring of the Handpiece in the OPEN direction.
mark) with the
8
Positioning
Fig. 1
Fig. 2
Fig. 3
Fig. 4