NSK VOLVERE i7 Bedienungsanleitung Seite 4

• This product is only for use in Dental Laboratory work. Do not use it for medical treatment.
• The system may present a possibility of malfunction when used in the presence of an electromagnetic
interference wave. Do not install the system in the vicinity of any device which emits magnetic waves. Turn off the
Main Power of the system as an ultrasonic oscillation device or an electrode knife is located close to the vicinity
of use.
• Use of an E-type Handpiece from a manufacturer other than NSK may lead to reduced rotation/torque
performance or generation of heat. Pay attention when using such a handpiece.
• Never use a Power Cord other than a genuine NSK Power Cord. Doing so may lead to an inability to maintain
quality.
• Do not use the product adjacent to or stacked with another device. If it is necessary to use the product adjacent
to or stacked with another device, verify that the product and the other device operate correctly before using
them.
• If the product overheats or smells of burning, immediately turn the power OFF, disconnect the Power Cord, and
contact your Authorized NSK Dealer.
• If you notice vibrations, generation of heat, abnormal sounds, or problems with the power supply, etc., cease
operation immediately and refer to "11. Troubleshooting".
If an inspection indicates that the cause of the problem is a part that cannot easily be replaced or the cause of
the problem cannot be identified, contact your Authorized NSK Dealer.
• Keep away from explosive substances and flammable materials.
• Conform to the allowable rotation speed specified by the manufacturer or distributor of the bur. Failure to do so
may lead to injury due to the bur breaking and scattering or the Motor Handpiece vibrating violently.
• Do not use burs that are unstable, bent, damaged or have wear on the shank. Doing so may lead to injury due to
the bur breaking or suddenly releasing from the chuck, etc.
• When using a disk, use it at as low a rotation speed as possible to prevent it from scattering due to breaking, etc.
• Since a grindstone may be unbalanced, even if new, make sure to perform dressing before using it. Using an
unbalanced grindstone may lead to injury due to it breaking and scattering.
WARNING
3