Technical Specifications; General Warning - Tractel blocfor B10 ESD Gebrauchs- Und Wartungsanleitung

Model
Weight (kg) with M10 and M47
GB
Length of galvanised steel rope device
46 mm wide strap device length (m)
25 mm wide strap device length (m)
16 mm wide strap device length (m)
Retraction force (N)
Braking distance (mm)
Horizontaluse
Min. L (m)
Max. M (m)
Device securing
Attaching the retractable lanyard

1. General warning

1. General warning
1.  B efore using your blocfor™ self-retracting fall-
arresterdevice,andtoensuresafe,effi  cientuseof
the harness, it is essential that the user be properly
trained in the use of the equipment and has read
and understood the information given in the manual
supplied by TRACTEL SAS. This manual should be
available at all times to all users. Additional copies
can be supplied on request.
2. Before use, it is essential that users are trained in
the use of this safety device. Check the state of
associated equipment and make sure that there is
adequate room for movement.
3.  T he blocfor™ self-retracting fall-arrester must only
be used by trained and skilled personnel, or under
the supervision of trained and skilled personnel.
4.  A ny blocfor™ self-retracting fall-arrester device
which does not appear to be in good condition or
which has already served to stop a fall should be
inspected, with all its associated equipment, by
TRACTELSASorbyaqualifi  edtechnicianwhomust
give written authorisation for re-use of the system.
It is recommended to make a visual inspection prior
to each use.
5.  A ny modifi  cation or attachment made to the
equipment cannot be done without prior written
approval from TRACTEL SAS. The equipment must
be transported and stored in its original packaging.
6.  A ny blocfor™ self-retracting fall-arrester which has
not been inspected over the past 12 months or
which has served to stop a fall must not be used.
They can only be used again after a new periodical
inspection carried out by an approved and competent
technician who can offer written permission for use.
10
Technical specifi cations Technical specifi cations
B10 ESD B6 ESD
4.86 2.22
10
4.7mm (m)
–
–
–
5 to 25 5 to 25
800
OK
3
1.5
Failing these reviews and approvals, the blocfor™
self-retractingfall-arresterwillbedisassembledand
destroyed.
7.  T he maximum working load for the blocfor™ self-
retractingfall-arresteris150kg.
8. If the weight of the user increased by the weight of
their equipment and tools is between 100 kg and
150 kg, you must ensure that the total weight (user,
equipment + tools) does not exceed the maximum
load of each of the components of the fall-arrest
system.
9. This device is suitable for use on an open air site
andforatemperaturerangeof-35°Cto+60°C.Avoid
any contact with sharp edges, rough surfaces and
chemical substances.
10. If you are responsible for assigning the equipment
11.  T he operator must be physically and mentally fi  t
12. The equipment should not be used beyond its limits
13.  T he blocfor™ self-retracting fall-arrester systems
14.  B eforeusingaEN363fall-arresterdevice,theuser
B5 ESD B2 ESD
2.17 1.02
– – –
– – 2
6 5 –
– – –
5 to 25 3 to 15
800 800 400
OK OK –
3 3 –
1.5 1.5 –
Anchor point
Operator
to an employee or similar person, ensure that you
comply with the applicable health and safety at work
regulations.
when using this equipment. In case of doubt, check
with one's private doctor or with the works doctor. It
is forbidden for use by pregnant women.
or in any other situation other than what it has been
designed for (cf. "4. Functions and Description").
should be personally assigned to each operator, in
particular where salaried personnel are concerned.
must ensure that each of the components is in good
working order: security system, locking system.
During installation, no damage should be made to
B1,8A ESD B1,8B ESD
0.98 0.98
– –
– –
– –
1.8 1.8
3 to 15 3 to 15
500 500
OK OK
1 1
0.5 0.5
Operator
Anchor point