Power Management - Pioneer VSX-933 Bedienungsanleitung

Setting Item Default Value Setting Details
Audio TV Out Off You can enjoy audio through the speakers of the
TV while this unit is on.
"On": When this function is used
"Off": When this function is not used
• The setting is fixed to "Auto" if "HDMI CEC" is
• Listening mode cannot be changed while "Audio
• Depending on your TV or input signal of the
• Audio is output from this unit if you operate the
Audio Return Auto (*) You can enjoy the sound of the HDMI-connected
Channel ARC-compatible TV through the speakers
connected to the unit.
* To use this function, set "HDMI CEC" to "On"
"Auto": When enjoying the TV sound through the
speakers of this unit
"Off": When not using the ARC function
Auto Delay On This setting automatically corrects
desynchronization between the video and audio
signals based on the information from the HDMI Lip
Sync-compatible TV.
"On": When enabling the automatic correction
function
"Off": When not using the automatic correction
function
set to "On". If you change this setting, set "HDMI
CEC" to "Off".
TV Out" is set to "On" and audio is being output
from the TV.
connected device, audio may not be output from
the TV even if this is set to "On". In such a case,
audio is output from the speakers of the unit.
MASTER VOLUME dial on this unit when audio
that is input to this unit is output from your TV
speakers. If you do not want to output audio,
change the setting of this unit or TV, or reduce
the volume of this unit.
beforehand.
Contents Connections
≫
„ Power Management
Change the settings for the power-save function.
Setting Item Default Value
Sleep Timer Off
Auto Standby On/Off
Auto Standby in Off
HDMI Standby
Through
92
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
You can allow the unit to enter standby
automatically when the specified time elapses.
Select a value from "30 minutes", "60 minutes" and
"90 minutes".
"Off": The unit does not automatically enter standby
mode.
This setting allows the unit to enter standby mode
automatically after 20 minutes of inactivity without
any video or audio input. (When "USB Power Out
at Standby" or "Network Standby" is enabled, the
unit enters the HYBRID STANDBY mode which
minimizes the increase in power consumption.)
"On": The unit automatically enters standby mode
("AUTO STBY" lights up).
"Off": The unit does not automatically enter standby
mode.
• "Auto Standby" is displayed on the main unit's
display and TV screen 30 seconds before
entering standby mode.
• "Auto Standby" does not work when Zone 2 is
active.
• Default values vary depending on the regions.
Enable or disable "Auto Standby" while "HDMI
Standby Through" is on.
"On": The setting is enabled.
"Off": The setting is disabled.
• This setting cannot be set to "On" if "Auto
Standby" and "HDMI Standby Through" are set
to "Off".
≫