Pioneer VSX-933 Bedienungsanleitung Seite 98

Setting Item Default Value Setting Details
Surround Right 0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with
• "63 Hz" can only be selected when this speaker
• If an item cannot be selected even though
Surr Back Right 0 dB After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with
• "63 Hz" can only be selected when this speaker
• The setting cannot be changed if "Zone 2" is set
• If an item cannot be selected even though
Contents
/ , adjust
/ .
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
/ , adjust
/ .
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
in "Configuration" - "Zone Speaker" and Zone 2
is on.
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
Connections
≫
Setting Item Default Value
Surr Back Left 0 dB
Surround Left 0 dB
Subwoofer 0 dB
• The result may not be as expected depending on the input source and listening mode
setting.
• If you want to make the adjustments while listening to something, press
controller, and select the Preset you want to adjust in "AV Adjust" - "MCACC" - "Manual
EQ Select" first.
98
Front Panel≫ Rear Panel≫ Remote≫
Playback Setup
≫ ≫
Setting Details
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with / .
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• The setting cannot be changed if "Zone 2" is set
in "Configuration" - "Zone Speaker" and Zone 2
is on.
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"63 Hz" and "16 kHz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with / .
• "63 Hz" can only be selected when this speaker
is set to "Large" in "System Setup" - "Speaker" -
"Crossover".
• If an item cannot be selected even though
connection is correct, check that the settings in
"System Setup" - "Speaker" - "Configuration"
- "Speaker Channels" matches the number of
connected channels.
After selecting the speaker frequency from between
"31 Hz" and "250 Hz" with the cursors
the volume of that frequency between "-12.0 dB"
and "+12.0 dB" with / .
• This cannot be selected if "No" is set in
"System Setup" - "Speaker" - "Configuration" -
"Subwoofer".
on the remote
≫
/ , adjust
/ , adjust
/ , adjust