Connecting The Power Cord; Connections And Use (S-11); Connecting The Speakers - Pioneer VSX-423-K Bedienungsanleitung

Connecting the power cord

Connect the power cord for the this unit to the
unit's power connector (AC IN), and the other
ends to an AC power supply. When turning on
the power, turn on the power to the receiver
first, then the power to this unit.
Operation
For details regarding operating part functions,
refer to Panel facilities on page 8.
1 Turn the POWER switch (5) ON.
• If the unit's power cord is connected to a
switched AC outlet on the receiver and
the switch is left ON, the unit can be
turned ON/OFF together with the
receiver.
• If the unit's power cord cannot be
connected to the receiver, turn the
power to the receiver ON before turning
the power to the unit ON. When turning
the power OFF, turn the power to the unit
OFF before turning the power to the
receiver OFF.
• Set the cross-over frequency to match
that of the speakers actually used.
2 Operate the receiver and adjust the
volume of the other speakers.
3 Adjust the volume of the bass with the
volume knob (2).
• Turn the knob slowly from the MIN
position.
4 Turn the POWER switch (5) OFF.
• The power indicator disappears.
• Do not use the speaker to output distorted
sound for long periods of time. This can
result in damages to the speaker and poses
a potential fire hazard.
10
En
ON
POWER
AC IN
Power Cord
Connections and Use
(S-11)
Connection
Before making or changing the
connections, switch off the power and
disconnect the power cord from the AC
outlet.

Connecting the speakers

To get the best out of your speakers it is
important that you connect them properly to
your receiver. Each speaker connection
consists of a positive (+) and a negative (–)
terminal. These should be matched between
the receiver and the speaker.
1 Attach one end of the supplied speaker
cord to the rear of the each speaker.
• Connect the wire with the colored
marker to the red (+) terminal; the plain
wire to the black (–) terminal. Press
down the spring-loaded tab and insert
the wire, as shown below. Release the
tab to secure the wire.
Red (+)
Black (–)
2 Connect the other end of each speaker
cord to your receiver.
• To connect, insert the colored wire into
the matching positive (colored) terminal
and the other wire into the negative
(black) terminal. See also the Operating
Instructions that came with your
receiver.
Red colored marker