How The Hood Works - De Dietrich DHD789X Betriebsanleitung

3/ HOW THE HOOD WORKS

The remote control has 6 buttons to control the hood. When you use the timer function button
(D), the hood will operate for 10 minutes before stopping automatically.
Remote control technical characteristics:
- Battery power
- Operating frequency
- Max. absorbed power.
- Operating temperature
- Dimensions
Operating description:
It has the following 6 buttons to control the appliance:
: lighting ON/OFF switch
01 : motor ON (first speed) OFF switch
 : second speed switch
 : third speed switch
 : fourth speed switch
: 10-minute timer
Standard configuration
The factory settings for the transmission code of all "hood remote controls" is the same
(dipswitch no. 6-7-8-9-10 to ON).
If two hoods are installed in the same area or in any case, one hood is installed in close prox-
imity to another, this could affect operation and therefore, it will be necessary to change the
code on one of the remote controls.
Changing the code
To change the transmission code for the remote control, proceed as follows: open the cover
and remove the battery then set one of the dipswitches 7-8-9-10 to OFF (dipswitch 6 must
remain set to ON).
Initialising the new code
Once the code on the remote control has been changed, proceed as follows:
Press the main stop button for the hood (Fig. B), then restore the electrical connection by
pressing the same button again (Fig. B); from this moment, you have 1 seconds to push the
ON/OFF button to synchronise the hood with the new code number.
Emergency stop button Fig 3B
If the remote control does not work, press the emergency stop button, which is located next to
the light. After any necessary repairs have been made, reset the emergency stop button.
These appliances are fitted with an electronic device that causes them to switch off automati-
cally  hours from the last control operation.
: 1V
: ,9 Mhz
:  mA
: -0 + 70 °C
: x7x1 mm.
1
EN