Electrical Hook Up Of The Hood - De Dietrich DHD789X Betriebsanleitung

Insert the pins into the holes (Fig. .1 – A) and screw the plate to the ceiling (Fig. .1 - B).
Then fix the lower structure (Fig. 6.) to the hood so that the holes meet up with the metric
screws welded to the fan support (Fig. 6.1). Insert the washers and nuts provided (Fig. 6.-A)
and tighten them using a suitable tool.
Join the air outlet pipe to the motor unit using a collar. Fit the top structure (Fig. 6.) into the
bottom structure and at the same time, adjust its position according to the required height
and above all to the minimum height necessary between the cook top and the hood. Secure
the two structures with screws (Fig. 6. B).
Then lift the hood with the structure and pipes already inserted until the four screws (Fig. 6.6
–E) hook onto the bottom structure (Fig. 6.C). Once the two parts have connected, fasten
them into place (Fig. .1, Fig. .) using the lock screws (Fig. .A).
Connect the hood pipe to the air exhaust opening.
Then insert the two telescopic pipes (Fig. 6. and 6.) into the bottom part of the hood; lift
the pipe completely and secure it to the hood with the screws provided (Fig. 10)- Raise the top
pipe as far as the ceiling and screw it into place (Fig. 6.6 –D).

- ELECTRICAL HOOK UP OF THE HOOD

This appliance is fitted with an H05 VVF 3 conductor, 0.75 mm2 (neutral, phase, and
ground) power cable. This can be hooked up to a 220 – 240 V mono-phase electrical net-
work by way of a CEI 60083 regulation power socket that must remain accessible after
installation, in conformity to installation regulations.
We decline all responsibility in case of accident caused by a lack of ground connection
or incorrect ground connection. The fuse used must be 10 or 16 A. If the power cable is
damaged, call the after-sales service to avoid any risk.
Attention:
If the hood presents some form of anomaly, unplug the appliance or remove the fuse corre-
sponding to the appliance's power line.
0