How The Hood Works - De Dietrich DHD9001X Betriebsanleitung

EN

3/ HOW THE HOOD WORKS

OFF switch: It is used to close the aspiration panel completely or to position it at interme-
diate heights at least cm 18 above the cooktop. While closing the aspiration panel keeps on
working at the speed set up to the height of cm 18 from the cooktop. Below this height the
aspiration function is automatically cut out.
On switch/+: It is used to extract the aspiration panel up to the maximum height of cm.
30 and to set automatically the first aspiration speed when reaching the height of cm 18 from
the cooktop.
When pressing the button again after reaching this height, the aspiration motor speed can be
encreased.
If the aspiration panel is positioned at an intermediate height between cm 18 and cm 30, the
aspiration panel can start raising again by pressing first the OFF switch and then the On/+.
Switch .
Leds: The different speed levels are indicated by blue leds. (1. Speed level corresponds to
the led down on the left).
MINUS SWITCH: it is working only if the position reached by the aspiration panel is higher
than mm 180 from the cooktop. It is used to decrease the aspiration motor speed.
TIMER SWITCH: it is used to stop automatically the aspiration system and to close auto-
matically the aspiration panel ten minutes it has been set.
Other functions:
- After 30 hours of appliance operation, the pushbutton panel indicates saturation of the grease
filters by the buttons flashing. To reset, press the timer button .
- After 4 hours of continuous operation from the last setting, the appliance turns off and closes
automatically.
- When the front panel is removed for cleaning and maintenance operations, all the electronic
aspiration and movement functions are locked.
- Anti pinching safety device: if anything is obstructing the closure operation of the downdraft,
the operation will stop and the downdraft will move up again.
35