Installing The Hood; Mounting The Hood - De Dietrich DHD789X Betriebsanleitung

EN

2/ INSTALLING THE HOOD

- During installation, or in the case of repairs, the appliance must be unplugged.
- Make sure that the electrical tension of the power source corresponds to the electrical tension in-
dicated on the information plate on the inside of the hood.
-If you need to modify the electrical layout of your house in order to be able to use the hood, call a
qualified technician.
- Never hook up the appliance to a discharge conduit used for combustion fumes (boilers, chimneys,
etc.) or a CMV unit (Controlled Mechanical Ventilation).
- The discharge conduit, whatever it may be, must never exit into the attic.
- Install the hood at a safe distance of at least 70 cm from the hob surface, whether they are electric,
gas, or mixed.
If you have an outlet to the outside:
Air exhaust to the outside is made possible by installing a separate DHK7000 motor (sold separately).
The hood needs to be connected to the separate DHK7000 motor using a tube with a diameter of at
least 1 mm. The tube should be flexible, in aluminium and non flammable. The tube must never
have a diameter of less than 1 mm. THIS HOOD IS NOT DESIGNED TO OPERATE IN RECIRCULATION
MODE.
ELECTRIAL HOOK UP
When you install the appliance and carry out maintenance, it must be unplugged from the
power source or the fuses must be disengaged or removed. Electrical hook up must be carried
out before the appliance is installed in the cabinet.
Check that:
- the power source is sufficient,
- power cords are in good condition,
- The diameter of the cables conforms to installation regulations.

- MOUNTING THE HOOD

Installation must conform to the regulations in force regarding the ventilation of
enclosed environments. In France, these regulations are container in the DTU 61.1 of the
CSTB. In particular, discharged air must not be channelled into a conduit used for exhaust
discharge or discharge from devices that operate with gas or other combustible materi-
als. The use of unused conduits is not permissible without the approval of a qualified
technician. The minimum distance between the hob surface and the lowest part of the
hood must be 70 cm. If the instructions for the cooker installed under the hood require
an even greater distance, this must take precedence.
- INSTALLATION
To prevent any damage to the appliance, remove the grease filters before installation. To
remove the grease filters, push the handle down towards the bottom of the hood and turn the
filter downwards, removing it from its seat at the same time (Fig. A).
Important: the installation process requires at least two people.
Before installing the hood, make sure that there is a nearby mains electricity point, position
the external controller and prepare the exhaust outlet opening.
Fix the extensions (Fig. , part A) to the top plate (Fig. ) using the screws provided. Position
the top plate (Fig..1) on the ceiling; make  holes (8 mm) as shown in the template.
9