How The Hood Works - De Dietrich DHD1100X Betriebsanleitung

3/ HoW THE HooD WoRKS

ImpoRTAnT: The hood functions will only switch on when the extraction panel is open.
It is used to close the aspiration panel completely or to position it at intermediate
heights at least cm 18 above the cooktop. While closing the aspiration panel keeps
on working at the speed set up to the height of cm 18 from the cooktop. Below this
height the aspiration function is automatically cut out.
It is used to extract the aspiration panel up to the maximum height of cm.
30 and to set automatically the first aspiration speed when reaching the height of
cm 18 from the cooktop.
When pressing the button again after reaching this height, the aspiration motor
speed can be encreased.
If the aspiration panel is positioned at an intermediate height between cm 18 and cm
30, the aspiration panel can start raising again by pressing first
The operating speeds shown by the white LEDs.
It is working only if the position reached by the aspiration panel is higher than cm 18
from the cooktop. It is used to decrease the aspiration motor speed.
It is used to stop automatically the aspiration system and to close automatically the
aspiration panel ten minutes it has been set.
The set function is shown by the flashing LED for the set speed.
To cancel the timer function, press the key again.
BooST:
It enables the motor to work at the maximum speed for 6 minutes and after that it drops back
at the 3 speed automatically.
rd
On the DHD1101X model being the 4th speed lower than what expressed in the Regulations
this function is not present.
ECo DESIGn:
Adjust the speed to the cooking method and the number of pans in use. It is preferable to use
the rings at the back of the range.
To make optimal use of your appliance, keep the length of the duct and the number of bends
in the duct to a strict minimum.
CALIBRATIon oF THE HooD:
After installing the hood and connecting the equipment to the electrical mains circuit, press the
red button positioned on the box of the electrical installation that is separated by the hood and
start the self-calibration procedure of the product by carrying out the following instructions:
1. Press the key to activate the extraction of the filter unit.
2. When the carriage has reached a height of 18 cms press the
rising.
3. Press the key and then the
The hood carries out the calibration of the filter unit by shifting the carriage up and down by
a few cms. During this phase the keys on the keypad flash.
key within 2 seconds.
25
En
and then
key to stop the carriage
.