Assembling And Adjustments; General; Fitting The Blade; Handle Height - Husqvarna FS400 LV Bedienungsanweisung

General

WARNING! Switch off the engine before
!
carrying out any checks or maintenance.
Check that the blade and the blade guard
are correctly fitted before starting the
machine.

Fitting the blade

• Wind up the cutting depth feeding wheel.
• Switch off the water tap. Disconnect the water hose
from the blade guard.
• Loosen the front nut and tilt the blade guard to service
position.
WARNING! Check that the blade, blade
!
flange and blade shaft are undamaged.
Clean the contact surfaces of the blade
and the blade flange. Make sure the
blade and the flanges are clean and free
of dirt and debris before mounting the
blade on the machine.
• Check the blade's direction of rotation. The arrow on
the blade indicates the direction of rotation.
8 – English

ASSEMBLING AND ADJUSTMENTS

• Fit the blade on the blade shaft (A). Fit the blade
flange (B) over the blade. Make sure that locking pin
on flange (A) passes through the blade and into the
flange (B). Tighten the screw (C) properly using the
supplied spanner.
• Refit the blade guard and water hose in reverse order
as set out for dismantling.

Handle height

The height of the lever can be adjusted in height.
• Loosen the screw. Set handle to most comfortable
working height. Tighten the screw.