Motar Hose (Fig. 3); Spray Lance (Fig. 4) - WAGNER PlastMax Originalbetriebsanleitung

PlastMax
2.6
(FIG. 3)
MORTAR HOSE
1 Material connection mortar spraying machine
2 Control cable connection / controller (automatic version
only)
3 Atomizing air connection compressed air supply
4 Material connection spray lance
5 Mortar hose
6 Atomizing air connection spray lance
7 Control cable connection/ automatic spray lance (auto-
matic version only)

2
1
7 6
3
5 4
2.7
(FIG. 4)
SPRAY LANCE
1 Material connection
2 Combined material and air tap:
Open: material tap at 90° to spray lance
Closed: material tap points forwards
3 Rendering tip:
Various rendering tips can be used in the rendering
lance. The tip size depends on the granular size of the
coating material and the desired spray pattern.
4 Hand-grip:
The hand-grip can mounted to either the right or left
side of the spray lance, depending on what is required.
The thread on the other side can be closed by way of the
attached stoppers for protection.
5 Control cable connection (automatic version only)
6 Air flow regulator
7 Atomization air connection

1
6
7
5 4
For work with the automatic spray lance,
you need a stronger compressor (e.g.
C330/03, accessory).
GB
2
3
37