Display Description - Leister WELDPLAST S1 Bedienungsanleitung

Operating unit description
Keyboard mode
Up (21)
Down (22)
Heating
on/off (23)
Minus (24)
Plus (26)
(press briefl y)
Minus (24)
Plus (26)
(press and hold)
Confi rmed (25)

Display description

Status display «Section 1» (29)
Profi le currently selected. If profi le names consist of more than 6 characters, the fi rst 6 characters
PE-HD
are shown fi rst, followed by the remaining characters.
1m16s Time remaining until the drive is released (1 min. 16 sec.)
Status display «Section 2» (30)
Drive released
Drive not released
Warning (carbon brushes / drive)
Key lock (only appears when key lock is activated)
Air and plasticizing heating is switched on
24
Current selection in the working
display
Changes the item within the wor-
king display
No function
Sets the required setpoint in 5°C or
5% stages.
Sets the required setpoint in 10°C
or 10% stages.
Set value is adopted straight away
and the selection goes straight back
to the function display
Current selection in the function
display
Changes from the function display
to the working display
Changes from welding mode to the
cooling process
Changes from the cooling process
to welding mode
Changes from the start display to
welding mode
Changes the item in the function
display
Changes the item in the function
display
Selected function is executed