Leister WELDPLAST S1 Bedienungsanleitung Seite 21

Operating Instructions
Read the operating instructions carefully before starting
the device and keep them for future reference.
Leister WELDPLAST S1
Extrusion Welder
Application
• Extrusion welding of the following materials:
PP / PE-HD / PVC-U / PVC-C / PVDF
• Other materials on enquiry
Warning
Opening the device is extremely dangerous, since live parts and connections are exposed.
Remove the plug from the socket before opening the device.
Danger of fi re and explosion if the extrusion welder is used incorrectly (e.g. overheating
of material), particularly near combustible materials and explosive gases.
Danger – can cause burns ! Do not touch bare metal parts and emerging material while
hot. Allow the device to cool. Do not direct stream of hot air or emerging material towards
people or animals.
Connect device to power socket with protective earth conductor. Any break in the
protective earth conductor inside or outside the device is dangerous!
Only use extension cables with a protective earth conductor!
Caution
The nominal voltage indicated on the device must correspond to the mains voltage. If
power failure occurs, the main switch and drive must be switched off (release locking
device).
When using the device on building sites, a residual current circuit breaker is essential
for the safety of persons there.
Risk of dazzling! Avoid direct eye contact with the LED light beam.
The device must not be left unattended when in use. Heat can reach combustible
materials which are out of sight.
The device may only be used by trained personnel or under their supervision. Children
may not use the device under any circumstances.
Keep away from wet and damp areas.
(Translation of the original operating instructions)
GB
21