Overhead Rigging - JB Systems LED CLUBHEAD Bedienungsanleitung

Vorschau ausblenden

Seite von 80

/ 80
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

ENGLISH

The exclamation point within the equilateral triangle is intended to alert the user to the presence

of important operation and maintenance (servicing) instructions in the literature accompanying

this appliance.

This symbol means: indoor use only

This symbol means: Read instructions

This symbol determines: the minimum distance from lighted objects. The minimum distance

between light-output and the illuminated surface must be more than 1 meters

 To protect the environment, please try to recycle the packing material as much as possible.

 A new light effect sometimes causes some unwanted smoke and/or smell. This is normal and disappears after some

minutes.

 To prevent fire or shock hazard, do not expose this appliance to rain or moisture.

 To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when bringing it

into a warm room after transport. Condense sometimes prevents the unit from working at full performance or may even

cause damages.

 This unit is for indoor use only.

 Don't place metal objects or spill liquid inside the unit. Electric shock or malfunction may result. If a foreign object

enters the unit, immediately disconnect the mains power.

 Locate the fixture in a well ventilated spot, away from any flammable materials and/or liquids. The fixture must be fixed

at least 50cm from surrounding walls.

 Don't cover any ventilation openings as this may result in overheating.

 Prevent use in dusty environments and clean the unit regularly.

 Keep the unit away from children.

 Inexperienced persons should not operate this device.

 Maximum save ambient temperature is 40°C. Don't use this unit at higher ambient temperatures.

 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging and servicing.

 Always unplug the unit when it is not used for a longer time or when you start servicing.

 The electrical installation should be carried out by qualified personal only, according to the regulations for electrical

and mechanical safety in your country.

 Check that the available voltage is not higher than the one stated on the rear panel of the unit.

 The power cord should always be in perfect condition. Switch the unit immediately off when the power cord is

squashed or damaged. It must be replaced by the manufacturer, its service agent or similarly qualified persons in order

to avoid a hazard.

 Never let the power-cord come into contact with other cables!

 This fixture must be earthed to in order comply with safety regulations.

 Don't connect the unit to any dimmer pack.

 Always use an appropriate and certified safety cable when installing the unit.

 In order to prevent electric shock, do not open the cover. there are no user serviceable parts inside.

 Never repair a fuse or bypass the fuse holder. Always replace a damaged fuse with a fuse of the same type and

electrical specifications!

 In the event of serious operating problems, stop using the fixture and contact your dealer immediately.

 The housing and the lenses must be replaced if they are visibly damaged.

 Please use the original packing when the device is to be transported.

 Due to safety reasons it is prohibited to make unauthorized modifications to the unit.

Important: Never look directly into the light source! Don't use the effect in the presence of persons suffering from

epilepsy.