Specifications - Makita JS3200 Bedienungsanleitung

ENGLISH (Original instructions)
1-1. Switch trigger
1-2. Lock button
2-1. Gauge for stainless: 2.5 mm (3/32")
2-2. Gauge for mild steel: 3.2 mm (1/8")
3-1. Hex wrench
3-2. Lower blade
3-3. Upper blade securing bolt
3-4. Upper blade
4-1. Tighten

SPECIFICATIONS

Max. cutting capacities
Min. cutting radius
Strokes per minute (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated in accordance with European Standard
and can, therefore, also be used from sockets without
earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : cutting sheet metal
Vibration emission (a
Uncertainty (K) : 2.5 m/s
Explanation of general view
4-2. Upper blade securing bolt
4-3. Upper blade
5-1. Blade holder
5-2. Upper blade securing bolt
5-3. Upper blade
5-4. No gap allowed
6-1. Lower blade positioning bolt
6-2. Lower blade
6-3. Upper blade
Model
Steel up to 400 N/mm
Steel up to 600 N/mm
Steel up to 800 N/mm
Aluminum up to 200 N/mm
-1
)
Overall length
Net weight
Safety class
) : 87 dB(A)
pA
) : 98 dB(A)
WA
2
) : 18.5 m/s
h
2
2
2
2
2
ENE037-1
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
ENF002-1
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENG102-3
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG218-2
3
7-1. Lower blade positioning bolt
7-2. Hex nut
7-3. Thickness gauge
8-1. Workholder
10-1. Cutting line
11-1. Limit mark
12-1. Screwdriver
12-2. Brush holder cap
JS3200
3.2 mm (10 ga.)
2.5 mm (13 ga.)
1.5 mm (17 ga.)
4.0 mm (9 ga.)
50 mm
1,600
204 mm
3.4 kg
/II
ENG901-1