Specifications - Makita BJN160 Betriebsanleitung

ENGLISH
(Original instructions)
1 Button
2 Red indicator
3 Battery cartridge
4 Die holder
5 Lock nut
6 Loosen
7 Wrench
8 Gauge for cutting stainless:
1.2 mm (3/64")
9 Gauge for cutting mild steel:
1.6 mm (1/16")
10 Notch

SPECIFICATIONS

Model
Max. cutting capacities
Min. cutting radius
Strokes per minute (min
Overall length
Net weight
Rated voltage
• Due to our continuing program of research and devel-
opment, the specifications herein are subject to change
without notice.
• Specifications and battery cartridge may differ from
country to country.
• Weight, with battery cartridge, according to EPTA-Pro-
cedure 01/2003
Intended use
The tool is intended for cutting sheet steel and stainless
sheet steel.
General Power Tool Safety Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and instructions for future
reference.
All manuals and user guides at all-guides.com
Explanation of general view
11 Slide switch
12 Indicating lamp
13 Die
14 Bolts
15 Hex wrench
16 Punch
17 Punch holder
18 Screw
19 Tighten
20 From the top view
21 Cutting at an angle to grooves
2
Steel up to 400 N/mm
2
Steel up to 600 N/mm
2
Aluminum up to 200 N/mm
Outside edge
Inside edge
–1
)
ENE037-1
GEA010-1
22 Cutting perpendicular to
grooves
23 From the side view
24 Corrugated or trapezoidal sheet
metal
25 Cutting head should be at a
right angle (90°) to cutting sur-
face.
26 Limit mark
27 Holder cap cover
28 Screwdriver
29 Brush holder cap
BJN160
1.6 mm/16 ga
1.2 mm/18 ga
2.5 mm/12 ga
50 mm
45 mm
1,900
313 mm
2.1 kg
D.C. 14.4 V
NIBBLER SAFETY WARNINGS
1. Hold the tool firmly.
2. Secure the workpiece firmly.
3. Keep hands away from moving parts.
4. Edges and chips of the workpiece are sharp.
Wear gloves. It is also recommended that you
put on thickly bottomed shoes to prevent injury.
5. Do not put the tool on the chips of the work-
piece. Otherwise it can cause damage and trou-
ble on the tool.
6. Do not leave the tool running. Operate the tool
only when hand-held.
7. Always be sure you have a firm footing.
Be sure no one is below when using the tool in
high locations.
8. Do not touch the punch, die or the workpiece
immediately after operation; they may be
extremely hot and could burn your skin.
9. Avoid cutting electrical wires. It can cause seri-
ous accident by electric shock.
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product
(gained from repeated use) replace strict adherence
to safety rules for the subject product. MISUSE or
failure to follow the safety rules stated in this instruc-
tion manual may cause serious personal injury.
BJN161
1.6 mm/16 ga
1.2 mm/18 ga
2.5 mm/12 ga
50 mm
45 mm
1,900
313 mm
2.2 kg
D.C. 18 V
GEB028-2
5