Mounting The Magnetic Sensor - Siko MS100/1 Originalmontageanleitung

MS100/1
Installation
Fig. 1: Mounting of the magnetic tape
Mounting examples
The simple mounting procedure by means of a beveled magnetic tape as
shown in
ments. In a non-protected environment there is the danger of peeling off.
Mounting approaches as shown in
such cases.
Optimum protection is provided by mounting in a groove as shown in
5. The groove should be deep enough so that the complete magnetic tape
will be embedded in it.
Fig. 2: Magnetic tape
beveled
Fig. 4: Magnetic tape screwed
from top

4.3 Mounting the magnetic sensor

Alignment of the magnetic sensor
NOTICE
` Take care that the magnetic sensor is aligned correctly in order to
1. Mount magnetic tape (see chapter 4.2).
MS100/1 · Date 27.04.2018 · Art. No. 82106 · Mod. status 118/18


Fig. 2
can only be recommended for very protected environ-
ensure optimum sensing (see




Fig. 3 Fig. 4
and
Fig. 3: Magnetic tape screwed
on the front
Fig. 5: Magnetic tape in groove
Fig. 6).
English
are more suitable in
Fig.
17