Target Group; Basic Safety Information - Siko MS100/1 Originalmontageanleitung

MS100/1
14 Safety information
NOTICE
WARNING
DANGER
WARNING
Important operating information that may facilitate operation or many
cause unplanned device reactions if disregarded including possible prop-
erty damage.
Signal signs

2.3 Target group

Installation instructions is intended for the configuration, commissioning
and mounting personnel of plant or machine manufacturers who possess
special expertise in drive technology. This group of operators needs pro-
found knowledge of a magnetic sensor necessary connections and its inte-
gration into a complete machinery.
Insufficiently qualified personnel
Insufficiently qualified personnel cause personal injury, serious damage to
machinery or magnetic sensor.
` Configuration, commissioning, mounting and maintenance by trained
expert personnel only.
` This personnel must be able to recognize dangers that might arise
from mechanical, electrical or electronic equipment.
Qualified personnel are persons who
• are familiar with the safety guidelines of the electrical and automation
technologies when performing configuration tasks;
• are authorized to commission, earth and label circuits and devices/
systems in accordance with the safety standards.

2.4 Basic safety information

Danger of explosion
` Do not use the magnetic sensor in explosive zones.
Movable parts
Bruising, rubbing, abrasing, seizing of extremities or clothes by touching
during operation any movable parts as for example sensor.
` Install protective facilities to prevent people from getting access.
MS100/1 · Date 27.04.2018 · Art. No. 82106 · Mod. status 118/18
English