Mounting The Magnetic Tape - Siko MS100/1 Originalmontageanleitung

MS100/1
16 Installation
CAUTION
NOTICE
NOTICE
NOTICE

4.2 Mounting the magnetic tape

External magnetic fields
Magnetic tape's magnetization gets lost. Any direct contact of the mag-
netic tape with magnetic fields (e. g. adhesive magnets or other perma-
nent magnets) is to be avoided. Sensor movements during power loss are
not captured by the follower electronics.
` Protect the magnetic tape from impact by external magnets.
Solving bonding of the magnetic tape
` Remove foreign anti-adhesive substances including oil, grease or dust
by means of detergents that are preferably evaporating residue-free.
Suitable detergents include ketones (acetone) or alcohol offered for
instance as fast cleaning agents by the Loctite or 3M companies.
` For optimum bonding, the surfaces to be bonded must be dry and
bonding shall be carried out with maximum contact pressure.
` Observe a bonding temperature between 20 °C and 30 °C in dry rooms.
Deterioration of measuring accuracy
` Mount the magnetic tape level with the mounting surface or distance
to be measured. Unevenness deteriorates measuring accuracy.
Length of the magnetic tape
` For technical reasons, the magnetic tape must be ≥47 mm longer than
the distance to be measured.
When applying long pieces of magnetic tape do not immediately remove
the complete protective film, but rather peel back a short part from the
end sufficient to fix the tape. Now align the tape. Now you can pull out lat-
erally the remaining length of the protective film, simultaneously pressing
the tape firmly onto the mounting surface. A wallpaper seam roller could
be used to assist in applying pressure onto the magnetic tape when fixing
it in position.
Mounting (Fig. 1):
1. Clean mounting surface
2. Remove protective film
3. Stick down the magnetic tape
4. Clean surface of magnetic tape carefully.
5. Remove protective film
6. Fix cover tape (both ends should slightly overlap).
7. Also fix cover tape's ends to avoid unintentional peeling.
MS100/1 · Date 27.04.2018 · Art. No. 82106 · Mod. status 118/18
carefully.
1
of the adhesive tape
2
.
4
of the cover tape
6 5
English
.
3
.