PIEPS DSP Pro Bedienungsanleitung Seite 22

B Att ErI ES
The battery compartment is located on the backside of the housing. The safety screw connection
can be easily opened and closed using a coin. Only use battery type alkaline LR03/AAA and
always replace all 3 batteries with new ones of the same type. Never use rechargeable batteries
and always change all batteries at the same time!
The battery indication is based on measuring the actual battery voltage. Due to the temperature
influence the actual battery voltage may vary. A change from cold (outdoor) to warm (mountain
hut) the battery capacity obviously recovers.
3/3 filled
2/3 filled
1/3 filled
empty
empty, flashing
IMPortAnt! During a longer time of no use (e.g. summer) the batteries have to be taken out
of the PIEPS DSP PRO/DSP SPORT. Damages because of leaked batteries are not included in the
warranty.
electromagnetic Compatibility (eMC) and PiePs auto-antenna-switch:
All beacons are very sensitive against electrical and magnetic interferences. Due to this, it's
a recommendation from all manufacturers that minimum distances should be maintained
between avalanche beacons and electronic, magnetic or metallic influences (like radios,
mobile phones, MP3-players, bunch of keys)!
pIEpS recommends: Minimum distance in SEND-mode: 15 cm | SEARCH-mode: 50 cm
Your pIEpS DSp pro/DSp SporT has an auto-antenna-Switch included:
If there is an external influence the strongest antenna will begin transmitting.
Further information can be found in the chapter "Intelligent Transmitter".
22 | 08/13
PIEPS DSP Pro
400–250 h SEND
250–120 h SEND
120–20 h SEND
20 h SEND (+10°C) + 1 h SEARCH (-10°C)
last reserve, transceiver can be switched off at anytime
PIEPS DSP SPort
200–120 h SEND
120–60 h SEND
60–20 h SEND