Shot of steam
Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the "max"(fig.3)position and wait until the pilot light
goes out
2. Press the shot of steam button for this function
3. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE!
For the best steam quality, do not use more than three
successive bursts each time. Several pumping actions
are needed to start this function.
NOTE!
Excessive use of this feature will cause the iron to cool ,
ensure that the pilot light is out, before operating the
shot of steam control.
AFTER USE
19
GB