Steam Ironing; Spray; Shot Of Steam - Fakir VEZUV Bedienungsanleitung

GB

Steam ironing

1. Fill the iron as described in the section "how to fill the water tank".
2. Plug the iron into the mains.
3. Steam ironing is only possible when the highest temperatures shown on the
temperature control are selected .
Otherwise ,water may escape through the soleplate.
4. Wait until the pilot light goes out , which indicates that the selected temperature has
been reached.
5. Turn the steam button to the required position.
6. When the ironing is finished and during breaks in ironing , place the iron in its upright
position.
7. Disconnect the iron from the mains supply . Pour of any remaining water and leave
the iron to cool off.

Spray

1. The spray can be used in any position, either in dry or steam ironing, as long as the
water tank is filled with water.
2. Press the spray button for this function
NOTE!
For the best steam quality, do not use more than
three successive bursts each time. Several
pumping actions are needed to start this function.

Shot of steam

Shot of steam give extra steam for removing persistent wrinkles.
1. Place the temperature selector at the "max"(fig.3)position and wait until the pilot light
goes out
2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.
NOTE!
For the best steam quality, do not use more than
three successive bursts each time. Several
pumping actions are needed to start this function.
VEZUV
16