Operating; Dry Ironing; Steam Ironing - Fakir RAPHAEL PLUS Bedienungsanleitung

GB
The appliance has two iron portions. You can use dry ironing or steam ironing, the
details refer to the following.

Dry ironing

1. Place the steam station on a stable and level surface.
2. Press the release button with one finger and grasp the iron's handle with the hand to
rotate the iron anti-clockwise to take out of the iron, and then put the iron on the
steam generator's front hook. And you do not need to secure the iron onto the
thermal insulating cushion during the operation and can just put the iron on the front
hook for convenient using.
CAUTION!
Avoid being hurt, never press the locking pin to take out
of the iron.

Steam ironing

1. Grasp the water tank's handle with the hand and press the trigger with one finger to
take out of the water tank, then open the filling cap and fill water into it. You had
better use purified water with less calcium particles. After it, close the filling cap. The
max capacity of water tank is 1.5L, the water level shall not be exceeded the MAX
mark.
2. Replace the detachable water tank properly.
3. Press the release button with one finger and grasp the iron's handle with the hand to
rotate the iron anti-clockwise (see Fig. 1) to take out of the iron, and then put the iron
on the steam generator's front hook. And you do not need to secure the iron onto the
thermal insulating cushion during the operation and can just put the iron on the front
hook for convenient using.
4. Connect plug to the wall outlet, press down the ON/OFF switch, and the defaulted
low steam rate indicator will flash. Turn temperature dial to your desired setting,
which is depended on the fabric of garment, and the temperature indicator will
illuminate. Refer to IRONING TIPS latter.
5. After a few minutes, the temperature indicator will be extinguished, it indicates the
soleplate temperature has achieved the selected temperature. If the indicator of
defaulted steam rate has been changed flashing to illuminating, it indicates you can
take out of the iron and iron the garment with steam by pressing the steam control
button of the iron.
6. According to your requirement, you can select the desired steam output for each
garment, there are three modes of low, medium, high on available. Make sure that
there is enough water in the tank.

OPERATING

24