Initial Setting - Yamaha YSP-1100 Bedienungsanleitung

MANUAL SETUP
HORIZONTAL ANGLE (Horizontal angle)
Use to adjust the horizontal angle of beams for each
channel. By adjusting the horizontal angle of the beams,
you can optimize the sound beam paths. A test tone is
automatically output.
( )
(+)
Choices: L90° to R90°
Adjust towards L (left) to move the direction of the output
to the left and adjust towards R (right) to move it to the
right.
a)HORIZONTAL ANGLE
Front L
L65deg
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
VERTICAL ANGLE (Vertical angle)
Use to adjust the vertical angle of sound beams for each
speaker. By altering the beam path, you can optimize
sound beam angles.
Choices: –45° to +45°
Initial setting: 0°
• Adjust towards – (minus) to move the angle downward.
• Adjust towards + (plus) to move the angle upward.
b)VERTICAL ANGLE 1/5
Front L
0deg.
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
Note
A test tone is automatically output.
64
En
(+)
( )
1/5
5 beam
L90 R90
*
0(deg)
p
0°
5 beam
(+)
------0deg.
(-)
p
BEAM TRAVEL LENGTH (Beam travel length)
A certain amount of delay must be applied to the sound
from each channel so that all sound will arrive at the
listening position at the same time. This menu sets the
distance that sound beams travel after being output and
reflected off the wall until they arrive at the listening
position and adjust the delay applied to the respective
channel.
The lines in the illustration below indicate the distance.
Choices: 0.3 m to 24.0 m
• Front L adjusts the distance the front left channel
sound beams travel.
• Front R adjusts the distance the front right channel
sound beams travel.
• Center adjusts the distance the center channel sound
beams travel.
• Surround L adjusts the distance the surround left
channel sound beams travel.
• Surround R adjusts the distance the surround right
channel sound beams travel.
c)BEAM TRAVEL LENGTH
. Front L;;;;;;;6.0m
Front R;;;;;;;6.0m
Center;;;;;;;;2.5m
Surround L;;;;9.1m
Surround R;;;;9.1m
[ ]/[ ]:Up/Down [ ]/[ ]:Sel
[ENTER]:Return
y
We recommend that you use the setting optimized by the AUTO
SETUP (see page 29). Set this menu only when you changed the
HORIZONTAL ANGLE (see page 64).
5 beam
p