Lenord, Bauer MiniCODER GEL 2449 Betriebsanleitung Seite 46

3 Prevention of damage
1
2
MiniCODER panel-mounting socket
1 Machine (e.g. spindle)
2 MiniCODER
3 Panel-mounting socket
4 Evaluation electronics
5 Equipotential bonding cable (only in case of extreme interference)
a Connecting cable with outer screen and three inner screens
b Inner screens (3×)
c Outer screen
 The MiniCODER is part of a machine or plant. Integrate the equipotential bonding
for the MiniCODER into the overall screening concept.
 Lay the signal cables and control cables physically separate from the power
cables. If this configuration is not possible, use screened twisted pair cables
and/or lay the MiniCODER cable in a steel conduit.
 Make sure that external protective measures against surge voltages have been
implemented (EN 61000-4-5).
46
Measuring system
3
c
4
b a
+5 V
Signal
GND
c
PE
5
Lenord + Bauer
GEL 2449