Lenord + Bauer
2.6.6
Check rotational speed calibration of MiniCODER and target wheel
The maximum rotational speed of the MiniCODER is limited by the internal electron-
ics. The maximum mechanical rotational speed is dependent on the target wheel
selected.
On the specification of a maximum mechanical rotational speed, the following formu-
la must be used to check whether the MiniCODER supports this rotational speed.
Maximum rotational speed =
The interpolation is dependent on the application. The following interpolations are
possible:
●
256 (application: rotational speed)
●
512 (application: standard)
●
1024 (application: positioning)
2.6.7
Testing and programming unit GEL 211CST4␣2M-
The MiniCODER can be tested and configured using the testing and programming
unit.
The following functions are available:
●
MiniCODER function test
●
Target wheel function test
●
Changing the resolution
GEL 2449
Interface information GEL 2449M
9
2.7 • 10
Number of teeth • Interpolation
2 Description
-1
min
41