Cleaning The Door Seal; Emptying The Condensate Tank - AEG Electrolux LAVATHERM 88840 Benutzerinformation

If the fine strainer is not fitted, the large mesh
filter will not snap into place and the loading door
cannot be closed.

Cleaning the door seal

Wipe the door seal with a damp cloth immediately after the drying cycle has finished.

Emptying the condensate tank

Empty condensed water container after every drying cycle.
Emptying of condensate water tank can be limited or fully eliminated in case of:
– open recirculation system if you use ProSteam programmes (See section Water recir-
culation system )
– direct drain system installation (See section Special accessories )
If the condensate tank is full, an active programme will break off automatically and the
message The tank is full. Please empty it and then press START. is shown in the display. In
order to continue the programme, the condensate tank must first be emptied.
WARNING!
The condensate is not suitable for drinking or for preparing foodstuffs.
1. Take out drawer containing condensed
water container completely 1 and pull up
the condensed water container's drain-
age pipe as far as it will go 2 .
2. Pour condensed water out into a basin or
similar receptacle.
3. Slide outlet connections in and refit con-
densate tank.
If the programme has been interrupted as
a result of the condensate tank being full:
Press the START PAUSE button to contin-
ue the drying cycle.
Care and cleaning
1
75
2