Putting In Extra Items Or Taking Items Out Before End Of Programme; Prosteam Programme Complete - AEG Electrolux LAVATHERM 88840 Benutzerinformation

66
ProSteam system

Putting in extra items or taking items out before end of programme

1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START PAUSE (START PAUSE) button to continue the drying cycle.

ProSteam programme complete

After the ProSteam cycle is completed , 0:00 starts flashing and alternatively the messages:
Finished. Please remove the laundry and Anti-crease appear in the display. If the buzzer
has been activated, an audible signal sounds at regular intervals.
The ProSteam programme is automatically followed by an anti-crease phase, in-
cluding brief steam phases, which lasts around 30 minutes.
The drum rotates during the anti-crease phase. This keeps the laundry loose and free of
creases. It can be removed at any time during the anti-crease phase, except during steam
injection phases (look for Steam Injection message in the display !). Laundry should be
removed as quickly as possible.
1. Open the loading door to remove the laundry.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care and cleaning" chapter.)
3. Remove laundry one garment at a time.
To retain the effects of the ProSteam treatment, clothes must be removed one gar-
ment at a time during the anti-crease phase and hung immediately on a clothes
hanger to dry (for at least 5-15 mins, depending on fabric and selected steam level).
Do up the buttons and tug the garment into shape, paying particular attention to
cuffs and seams.
4. Turn the programme knob to OFF.
After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container if you do not use water recirculation system (See
chapter "Care and Cleaning".)
5. Close door.