Setting Delay (Startuitstel) Function - AEG Electrolux LAVATHERM 88840 Benutzerinformation

64
ProSteam system
LONG ANTICREASE
A 90 minute anti-crease phase is set. The display now shows the long anti-crease icon.
If this additional option is selected, the anti-crease phase (30 min.) at the end of the ProS-
team cycle is lengthened by 60 minutes. The laundry can be removed at any time during
the anti-crease phase.
BUZZER
The appliance is supplied with the BUZZER function deactivated. The button is used to
switch the function on or off. When the function is active, the BUZZER symbol appears in
the display.
The buzzer sounds or plays a tune during:
– cycle end
– anti-crease phase and when phase starts or ends
– cycle interruption by a warning
– alarm
CHILD LOCK
The child lock can be set to prevent a programme being accidentally started or a programme
in operation being accidentally changed. The child safety device locks all buttons and the
programme knob. The child safety device can by deactivated by holding down the OPTION
(OPTIE) and OK buttons simultaneously for 5 seconds.
– Before programme is started: appliance cannot be used
– After programme is started: programme in operation cannot be changed
The child lock icon appears in the display to indicate that the child lock is activated. The
child lock is not deactivated once the programme comes to an end. If you want to set a
new programme, you must first deactivate the child lock.
SPIN SPEED
If the washing in the washing machine was initially drained prior to the ProSteam cycle,
the dryer can be set according to the spin speed of the initial drainage procedure. The higher
the spin speed was, the shorter the programme length for the drying cycle.
Activate the SPIN SPEED option and then number of times press OPTION (OPTIE) button
until the desired spin speed of the initial drainage is displayed. No value is shown if no spin
speed is selected.
In certain programmes the spin speed has not effect (time controlled cycles), its selection
can be not selectable and only three dashes are visualized. Available selections: from 800
to 1800 rpm's in 100 rpm's intervals.
The maximum value depends by selected program, the minimum is always 800 rpm
For those programs where the spin speed has no effect (time controlled cycles), the selection
is not allowed and three dashes "- - -" are displayed that has the meaning of not set or
unknown.
The user interface always remembers last spin selection, and proposes it as default for all
new selected programs. If memorized spin speed is greater than maximum allowed value
it will be automatically reduced to max spin speed available for the selected program.

Setting DELAY (STARTUITSTEL) function

With the DELAY (STARTUITSTEL) button, you can delay the start of a ProSteam pro-
gramme by between 30 minutes and a maximum of 20 hours.