Machine Settings - AEG Electrolux LAVATHERM 88840 Benutzerinformation

80

Machine settings

Drying cycle ends shortly after
programme starts. Finished
message is displayed.
Drying cycle lasts an unusually
long time. Note: After around 5
hours the drying cycle ends au-
tomatically (see „Drying cycle
complete ").
Discolouration
Changing the bulb for interior lighting
Only use a special bulb which is designed specially for dryers. The special bulb can be
obtained from your local service centre.
When the appliance is switched on, the interior lighting switches itself off after 4 minutes
when the door is open.
WARNING!
Do not use standard bulbs! These develop too much heat and may damage the machine!
Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully
unscrew or deactivate the fuse.
1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,
at the top; refer to "Description of machine" section.)
2. Replace defective bulb.
3. Screw cover back down.
Check the correct positioning of o-ring gasket before screwing back the door light cover.
Do not operate the dryer when missing o-ring gasket on door light cover.
WARNING!
For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer
must not be operated.
Machine settings
The special options that can be set under SETTINGS remain permanently stored independent
of each drying cycle – even after the appliance has been switched off or the mains plug
has been removed from the socket.
Not enough washing loaded or
washing loaded is too dry for
selected programme.
Lint filter clogged.
Fluff filter clogged.
Load volume too big.
Laundry insufficiently spun.
Particularly high room temper-
ature.
Colour fastness of textiles.
Select time programme or
higher drying level (e.g. CUP-
BOARD DRY (KASTDROOG) in-
stead of DAMP (VOCHTIG)).
Clean lint filter.
Clean fluff filter.
Reduce load volume.
Laundry must be adequately
spun.
Automatic process, there is no
fault with the appliance. If pos-
sible, lower the room tempera-
ture.
Check colour fastness of tex-
tiles. Only treat textiles togeth-
er if they are a similar colour.