AEG Electrolux LAVATHERM 88840 Benutzerinformation Seite 82

82
Machine settings
CONTRAST
1. Press OPTION (OPTIE) button until CON-
TRAST selected.
2. Press OK to confirm - frame around bar
indicator starts blinking.
3. Press OPTION (OPTIE) until you set right
contrast level.
4. Press OK to confirm.
WATER HARDNESS
Water contains, a variable quantity of limestone
and mineral salts of which quantities vary accord-
ing to geographical locations thus varying its con-
ductivity values.
Relevant variations of the conductivity of the wa-
ter compared to those prefixed by the factory
could slightly influence the residual humidity of
the laundry at the end of the cycle. Your dryer
allows you to regulate the sensitivity of the drying
sensor based on conductivity values of the water.
1. Press OPTION (OPTIE) button until WATER HARDNESS selected.
2. Press OK to confirm - frame around bar indicator starts blinking.
3. Press OPTION (OPTIE) until you set right hardness level.
4. Press OK to confirm.
available selections:
– MIN - low conductivity <300 micro S/cm
– MED - medium conductivity 300-600 micro S/cm
– MAX - high conductivity >600 micro S/cm
MED is set as default.
FULL TANK WARNING - ON/OFF
The container indicator at the end of the pro-
gramme can be deactivated, for example, if an ex-
ternal condensed water drain is installed.
1. Press OPTION (OPTIE) button until FULL TANK
WARNING selected.
2. Press OK to confirm - frame around bar indi-
cator starts blinking.
3. Press OPTION (OPTIE) until you set right status.
4. Press OK to confirm.
SETTINGS
BRIGHTNESS
CONTRAST
WATER HARDNESS
SETTINGS
CONTRAST
WATER HARDNESS
FULL TANK WARNING
SETTINGS
WATER HARDNESS
FULL TANK WARNING
Back
9
MAX
ON