Special Accessories - AEG Electrolux LAVATHERM 88840 Benutzerinformation

7. Unscrew cover plates D from the front
of the machine, rotate through 180°,
screw on the opposite side.
Unscrew door lock E , push down slightly
8.
and remove from the front of the ma-
chine.
9. Press snap-in button F in and down,
press cover down slightly and remove from front of the machine.
10. Change door lock E over to the opposite side, screw down the door interlock.
11. On the other side, insert cover F and allow snap-in button to lock into place.
12. Insert loading door and hinges into recesses on the front of the machine and screw
down.
Note regarding contact protection: The machine is only secure for operations again once
all plastic parts have been inserted.

Special accessories

• Stacking kit
These intermediate installation kits can be used to arrange the dryer and a washing
machine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing
machine is at the bottom and the dryer is at the top.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
• Draining kit
Installation kit for direct draining of the condensed water into a basin, siphon, gully, etc.
The water reservoir then no longer has to be drained, it must however remain in its
intended position in the machine.
Fixed hose has to be on the suitable height from minimum of 50 cm to maximum of 1
m from floor level and cannot be looped. If possible shorten the draining hose.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
• Pedestal with the drawer
To situate the dryer at the optimal height and have some additional space to store (e.g.
laundry).
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
Installation
D
E
F
E
D
53
F