Changing A Programme; Putting In Extra Items Or Taking Items Out Before End Of Programme; Drying Programme Complete - AEG Electrolux LAVATHERM 88840 Benutzerinformation

The progress bar and the name of currently performed phase, above it, show stage of the
cycle.
With wet laundry, after a few minutes the appliance will show the correct programme
duration and foreseen time of cycle end.
It is normal for the appliance to make noises during drying programme if garments with
hard parts, such as metal buttons, are put in the drum.

Changing a programme

To change a programme which has been selected by mistake once the programme has
started, first turn the programme selector to OFF and then reset the programme.
The programme can no longer be changed directly once the programme has started.
If you nevertheless attempt to change the programme with the programme knob
the following message is shown:
Please turn programme selector to the last used position.
The drying programme is not however affected by this.

Putting in extra items or taking items out before end of programme

1. Open loading door.
WARNING!
Laundry and drum can become hot. Risk of burns!
2. Load or remove laundry items.
3. Close loading securely. Lock must audibly lock.
4. Press the START PAUSE (START PAUSE) button to continue the drying cycle.

Drying programme complete

After the drying cycle is completed , 0:00 starts flashing and alternatively the messages:
Finished. Please remove the laundry and Anti-crease appear in the display. If the buzzer
has been activated, an audible signal sounds at regular intervals.
The drying programme is automatically followed by an anti-crease phase, including
brief steam phases, which lasts around 30 minutes.
The drum rotates during the anti-crease phase. This keeps the laundry loose and free of
creases. It can be removed at any time during the anti-crease phase. Laundry should be
removed as quickly as possible to prevent creases from forming.
1. Open the loading door to remove the laundry.
2. Before removing the laundry, remove fluff from the micro-fine filter. It is best to use
a damp hand for this purpose. (See "Care and cleaning" chapter.)
3. Remove laundry.
4. Turn the programme knob to OFF.
After each drying cycle
– Clean the micro-fine filter and fine filter
– Drain the condensed water container (See chapter "Care and Cleaning".)
5. Close door.
71
Drying