Connect The Scanner - Xerox DocuMate 3640 Benutzerhandbuch

Installation
NOTE: If you do not see this on-screen diagram for connecting the scanner, stop and follow the
instructions below.

Connect the Scanner

1. Plug the power supply into the power port on the scanner.
NOTE: Only use the power supply (HEG42-240200-7L made by HiTron) included with your scanner.
Connecting any other type of power supply may damage your scanner, and will void its warranty.
2. Plug the power cord into the power supply and into a wall outlet.
3. Remove any tape from the USB cable.
4. Plug the flat end of the USB cable into an available USB port on the back of the computer.
DocuMate 3640 9
User’'s Guide