Connecting The Telephone; Modem Connection; T-Net Set-Up; Indication Of Charges In The Display - AUDIOLINE 300G Bedienungsanleitung

AUDIOLINE TELEPHONE 300G
2.4

CONNECTING THE TELEPHONE

Insert the small mains power supply plug into the socket at the rear of the telephone and the
plug-in power supply into a properly installed mains socket.
Connect the telephone cable provided to the telephone jack and the telephone socket on
the rear of the telephone. The AUDIOLINE 300G works using the TTD system (Touch-Tone
Dialling).
2.5

MODEM CONNECTION

The 300G telephone has a "MODEM" connection socket for a modem or fax machine on the
rear of the unit. Please note that this connection uses the same telephone line as the
telephone itself. The connected device cannot be used at the same time as the telephone.
2.6

T-NET SET-UP

Your AUDIOLINE telephone supports the most important DEUTSCHE TELEKOM added
value functions (e.g. brokering, call waiting, three-way conference, etc.). For these, you will
need the "FLASH" setting on your telephone. More information can be found in item 5.
Please contact DEUTSCHE TELEKOM to gain access to these functions (some of which are
subject to charge).
2.7

INDICATION OF CHARGES IN THE DISPLAY

Call charge information can be transmitted from the DEUTSCHE TELEKOM telephone network.
You can find out from the appropriate network operator whether charge information can also be
transmitted from private suppliers. Your telephone will show the charges incurred in the display.
Moreover, the cost of the last call and the total charges can be interrogated at any time. For
more information, see Chapters 3.11 and 3.12. The charge for one unit is preset to DM 00.12. If
this value should ever change, you can find out from Chapter 6.3 how you can set the new value
INSTALLATION
39