Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
Installing the appliance
Important: Unplug your oven before performing installation or maintenance!
Installation should be carried out according to the instructions by a professionally qualified person.
The manufacturer declines all responsibility for any damage to persons, animals or things due to a wrong installation.
Fitting the appliance
• Fit the appliance into its surround (beneath a work-top
or above another appliance) by inserting screws into
the 2 holes that can be seen in the frame of the oven
when the door is open.
• For the most efficient air circulation, the oven should be
fitted according to the dimensions shown in the figure.
• The rear panel of the cabinet must be removed so that
air can circulate freely. The panel to which the oven is
fitted should have a gap of at least 70 mm at the rear.
Note: Where ovens are to be matched with hobs,
!
it is essential to follow the instructions contained
in the booklet supplied with the other appliance.
48
For a built-in oven to work well the cabinet must be of the
right type. The panels of the adjoining furniture should be
heat resistant. Particularly when the adjoining furniture
is made of veneered wood, the adhesives should be able
to withstand a temperature of 120°C. Plastic materials or
adhesive which cannot withstand this temperature will be-
come deformed or unstuck.
To comply with safety regulations, once the appliance has
been fitted it should not be possible to make contact with
the electrical parts.
All parts which offer protection should be fixed in such a
way that they cannot be removed without the use of a tool.
Werbung
Kapitel
Inhaltsverzeichnis
