E7: Pump Status Detection; Reading Out The Number Of Cleaning Cycles; Cleaning Cycles In 24 Hours; Total Cleaning Cycles - Oase ProfiClear Premium TF-L gepumpt EGC Gebrauchsanleitung

7.5.4

E7: Pump status detection

The pump status detection signals via the system message Er88 if the pump is operating correctly. The
status detection is activated in the default setting.
Proceed as follows
1s
Press several times until E7 appears in
t
the display.
2
Keep pressed for 5 s until the value 0 or
n
1 is indicated in the display.
d
3r
Press to change the value.
d
7.6

Reading out the number of cleaning cycles

7.6.1

Cleaning cycles in 24 hours

How to proceed
Press and
7.6.2

Total cleaning cycles

How to proceed
Press and
7.7

Loading default settings

How to proceed
Press and
the display.
Information
Settable range: 0 or 1
Information
The sum of the automatic and time-dependent cleaning cycles is saved.
for 5 s.
The 4-digit value is displayed by two groups of two digits that appear in
succession in the display.
Example:
01-17: Corresponds to 117 cleaning cycles
The number is repeated five times after an extended pause to make it
easier to read:
01-17---01-17---01-17---01-17---01-17
Note:
If the mains voltage is switched off, the counter is reset to 0.
Information
The sum of the automatic, manual and time-dependent cleaning cycles is
for 5 s.
saved. The 8-digit value is divided into four groups of two digits that appear
in the display in succession.
Example:
00-00-12-44: Corresponds to 1244 cleaning cycles
The number is repeated four times after an extended pause to make it
easier to read:
00-00-12-44---00-00-12-44---00-00-12-44---00-00-12-44
Note:
If the mains voltage is switched off, the number of cycles is rounded off to
the nearest hundred and saved.
Information
All individually set values will be overwritten!
for 10 s until rE appears in
The following values are set:
− To cancel and exit the menu: Either wait for 10 s or press
− To cancel and exit the menu: Either wait for 5 s or press
− 0: The pump status detection is deactivated.
− 1: The pump status detection is activated.
− Cancel without saving and exit the menu: Press
− Cleaning time CL: 10 s
− Extended cleaning time EC: 20 s
− Interval of the time-dependent cleaning In: 20 min
- EN -
or .
or .
or .
63