Symbols; Your Watercourse And Waterfall Pump; Conventional Use; Safety Instructions - Oase Atlantis 30 Gebrauchsanweisung

Notes on the instructions
Use these operating instructions to familiarize yourself with the device before plac-
ing in service. You must observe the safety instructions for correct and safe use.
For safety reasons, children and young people under 16 years of age, as well as
people that cannot recognize possible hazards, or who are not familiar with
these operating instructions may not use this device.
Please keep these operating instructions in a safe place! If this device changes
hands, then please include these operating instructions along with the product.

1. Symbols

The symbols used in this operating manual have the following meaning:

2. Your watercourse and waterfall pump

1 Pump filter
2 Jet-Clean System
3 Flow-rate valve
4 Pump housing
5 Motor housing

3. Conventional use

With the Atlantis you create watercourses and waterfalls in your garden. The new
Jet-Clean System convenient cleaning possible while the pump is in operation.
Please insure that the height difference between pond/pump and spring is not too
large, insure that this difference corresponds to the capacity of the pump.
The Atlantis has been designed exclusively for underwater use at a water tem-
perature between +4 °C and +35 °C.

4. Safety instructions

Power connection
The combination of water and electricity can result in serious hazard to life and
limb in the case of improper electrical connection or improper handling.
-
-
-
-
-
10
Atlantis 30 Exp..p65
GB Operating instructions
Attention! Important hazard information!
Important information!
Attention! Unplug the power plug!
For your own safety, please contact an electrical specialist for questions and
problems.
Attention! The device may not be operated if cable or housing are defective!
Attention! Do not operate the device if there are people in the water Unplug
power plug!
Attention! Always unplug the power plugs of all devices in the water before
reaching into the water.
Compare the supply voltage (V) and the supply frequency (Hz) of your mains
power with the data on the nameplate. These data must agree.
10
GB
06.03.2003, 14:20