Intended Use; Installing The Pump - Oase Aquarius Fountain Set Classic 750 Inbetriebnahme

Intended use

Only use the product described in this manual as follows:
• Pumping of normal water for creating fountains.
• Operate in accordance with instructions.
The following restrictions apply to the unit:
• Do not use in swimming ponds.
• Never use the unit with fluids other than water.
• Never run the unit without water.
• Do not use for commercial or industrial purposes.

Installing the pump

WARNING
Death or serious injuries from hazardous electrical voltage due to operation of this
unit in a swimming pond.

Never operate the unit in a swimming pond.
 B
• Ensure that the connection to the power supply is at least 2 m from the pond.
• Place the pump horizontally on a stable, mud-free surface.
• The pump is under water, the nozzle intake emerges from the water.
TIP! Thoroughly clean the pond or pool and place the pump approx. 200 mm above
the bottom of the pond, so that no muddy water runs through the pump.
• Muddy water will cause the nozzle to clog faster and the impeller unit to become
worn prematurely.
Commissioning/start-up
NOTE
Never connect the pump to a dimmer. Otherwise the pump will be destroyed.
• Switching on: Plug the power plug into the outlet.
– The unit switches on immediately.
• Switching off: Pull the power plug from the outlet.
8