Electrolux WASL6E 201 Benutzerinformation Seite 24

24 electrolux
Problem
The display tells to
check the door.
The display tells
there is a water
alert.
PROBLEM WITHOUT ALARM MESSAGE
Problem
The appliance does
not drain the water.
The spin phase does
not operate.
The programme
does not start.
There is water on the
floor.
You cannot open the
appliance door.
The appliance makes
an unusual noise.
The appliance fills
with water and drain
immediately.
The washing results
are not satisfactory.
Possible cause
The connection of the water
drain hose is not correct.
The appliance door is open or
not closed correctly.
The anti-flood device is activa-
ted.
Possible cause
A washing programme without
the drain phase is set.
The function Rinse Hold is on.
The spin phase is off.
The filter of the drain pump is
blocked.
Balance problems with the
laundry load.
The mains plug is not connec-
ted in the mains socket.
Blow out fuse in the household
fuse box.
You did not touch button
The delay start is set.
The Child Lock function is acti-
vated.
Leakages from the couplings
of the water hoses.
Leakages from the drain
pump.
The water drain hose is dam-
aged.
The washing programme is in
operation.
There is water in the drum.
Incorrect level of the appli-
ance.
You did not remove the pack-
aging and/or the transit bolts.
The load is very small.
The end of the drain hose is
too low.
The detergent you used was
not sufficient or correct.
Possible solution
Make sure that the connection is cor-
rect.
Close the door correctly.
• Disconnect the appliance.
• Close the water tap.
• Contact the service centre.
Possible solution
Set the drain programme.
Set the drain programme.
Set the spin programme.
Clean the filter of the drain pump. Refer
to 'Care and cleaning'.
Adjust manually the items in the tub and
start the spin phase again.
Put in the mains plug.
Replace the fuse.
6
. Touch button
If necessary to wash the laundry imme-
diately, cancel the delay start.
Deactivate the Child Lock function.
Make sure that the couplings are tight.
Make sure that the drain pump filter is
tight.
Make sure that the water inlet hose has
no damages.
Let the washing programme end.
Set the drain or the spin programme.
Adjust the level of the appliance. Refer
to 'Installation'.
Remove the packaging and/or the trans-
it bolts. Refer to 'Installation'.
Add more laundry in the drum.
Make sure that the drain hose is in the
correct position.
Increase the detergent quantity or use a
different one.
6
.