Use And Operation - Klarstein 10032291 Bedienungsanleitung

EN
12

USE AND OPERATION

Important Notes on Use
• The kettle must be placed on a stable, flat and dry surface.
• Before first use fill the kettle up to the maximum level,boil the water, pour it out
and rinse the kettle. Repeat the procedure several times to remove manufacturing
deposits, etc.
• The kettle turns off automatically when the water has boiled.If necessary you may
turn it off using ON/OFF button (10).
• After the water has boiled or the kettle has been switched off, wait several seconds
before switching it on again.
• If you switch the kettle on without water, the overheat protection will automatically
shut the appliance off. Leave the kettle to cool down for about 15 minutes before
refilling.
Boiling Water
1 Before filling with water, remove the kettle from the base (4).
2 Open the lid and fill the kettle with water up to the desired level (between 0.5 and
1.0 L).
3 After plugging the base to the power outlet, the display turns on for a moment,
all buttons are lit and the appliance beeps twice which means that the base is
connected to the power source and the kettle is placed on the base.
4 Close the lid and place the kettle on the power base (4), the appliance beeps
once, the display turns on and the ON/OFF button stars to flash blue. Below the
horizontal line on the display you will see the current water temperature which will
be visible for about 5 seconds. If you do not perform any actions, the kettle turns off
automatically.
5 Press the ON/OFF button (10) without setting other functions.The kettle turns on and
beeps, the ON/OFF button will be lit red. The kettle boils water up to 100 , then
switches off automatically and beeps three times.
Heating up Water
If you just want to heat up the water, use the boiling temperature buttons
Press once to change the temperature. The temperature setting will be shown on the
display. You may select between the predefined temperature settings: from 40 up
to 100 press each 1 ,long-press each 5 . If the temperature set is lower than the
temperature of water in the kettle, the kettle switches off.
7.After reaching the desired temperature of water, the kettle switches off and beeps
three times.
and .