Installing/Removing Self-Propelling Wheels (Optional) - Invacare Aquatec Ocean Ergo Gebrauchsanweisung

4.2.6 Installing/Removing self-propelling wheels (optional)

IMPORTANT!
– When the self-propelling wheels are fitted, the
rear castors must remain locked.
– The hubs and the parking brakes for the
self-propelling wheels must be fitted by a
qualified technician. Assembly is described in
the assembly instructions "Assembling the hubs
and brakes for Aquatec® Ocean 24" wheels".
1. Align all four castors in the driving direction.
2. Lock all castors.
3. Push the axle D on the self-propelling wheel inwards.
(The handrims project outwards.)
4. Press and hold the button F on the outside of the axle.
This releases the retaining balls C at the end of the axle.
5. Raise the shower and toilet commode slightly.
1639501-A
6. Insert the axle into the hub B and push in the
self-propelling wheel onto the axle until the end stop E.
7. Release the button F.
8. Check that the retaining balls are behind the hex nut A.
9. The assembly is the same for the right and left
self-propelling wheel.
To remove the wheels, carry out the same procedure in
the reverse order.
Setup
15