BADU Eco Motion Bedienungsanleitung Seite 29

The "Info" screen
The safety enable contacts S1 and S2 have to be
switched with the internal auxiliary voltage of 24 V so that
the pump can be started. A jumper is already inserted in
the factory
The display value of the pump's consumption is not a real
measured value, but is rather based on measurements and
calculations of the highest possible power input of the pump.
The display value is only calculated with reference to the motor
speed and not the actual load.
09|2018
In the "Info" screen time-controlled
filtering can be switched on and off by
using the "F1" button. The filter times
are set in the menu under "Filter".
The operating mode that is currently
active is displayed at the top right of the
display.
When "Filter" is activated, "Filter" or
"F.Pro.x" is displayed with "x" standing
for the programme number which can
vary from 1 to 8. When "Filter" is
displayed, the filter programme is
activated, but no programme is currently
stored.
The "F2" button opens the "Extra" menu.
The speed can be turned up and down
temporarily by using the cursor buttons.
This change is reset when a new action
is taken, for example when a new filter
programme is started.
The display of the time, operating hours,
current consumption, total consumption
and the next backwash is rotated
automatically. However, it can also be
changed manually by using the left and
right cursor buttons.
EN 29