BADU Eco Motion Bedienungsanleitung Seite 41

Connection example: BADU OmniTronic - Backwash valve
When the pump is used in combination with the BADU
OmniTronic backwash valve, this has to be connected in
accordance with the installation example. To this purpose
the enable contact S1 or S2 and 24 V of the pump have to
be connected with the contacts Z1 and Z2 of the BADU
OmniTronic. The relays has to be set at the BADU
OmniTronic. In addition, relay 11 has to be connected with
the "Manual backwash" input of the BADU OmniTronic.
The required speed and the period for backwashing and
rinsing have to be set in the "Backwash" menu of the
pump. The periods have to be set so that the sum of the
backwash and rinsing period of the pump is equal to the
sum of the backwash and rinsing period of the BADU
OmniTronic + approx. 2 minutes for the position change.
09|2018 EN 41