Fault log
Basic settings
Reset
If the buttons "F1", "F2" and the cursor button "up" are pressed
simultaneously for a minimum of 5 seconds, the unit will be reset
to the factory settings.
Overview of the various operating modes
FILTER
F.PRO. 1 - 8
MANUAL
PRIMING
BACKWASH
ANALOGUE
EXT. 1 - 6
EN 36
If a fault occurs the red LED in the user
interface will start to blink. The
corresponding fault code and fault name
will be shown in the fault log on can be
acknowledged by pressing the OK
button.
The following settings can be carried out
in the basic setting:
•
Language: German, English,
French, Dutch, Italian and Spanish
•
Time display: 24h, 12h
•
Time and weekday
•
Display contrast: 1 - 10
•
Display Ecomode: 1 - 10 Minutes
•
Display of the speed: %, rpm
•
Reset
•
Child lock: On/Off
•
Software version
Filtering is switched on, but no filter programme
is programmed at the current time.
A filter programme 1 - 8 is active.
A programme from the "Extras" menu is started
manually.
The priming mode is currently active.
The backwash process was started
automatically and is active.
The pump is controlled by an analogue external
signal.
The pump is controlled by a digital external
signal.
09|2018