Vermeiren Eclips X4 kids 90 Gebrauchsanweisung Seite 16

Adjustment of the slope nuts Ⓒ from the steering wheels.
L
WARNING:
Risk of injury - Make sure that the eccentric screw settings are
identical on both front-wheel adapters and, before using the wheelchair.
This figure illustrates the principle. The position of the screw thread is indicated by a number.
* Rear wheel:
1.
Remove the rear wheels (see § 2.12).
2. Loosen the fixing screws Ⓐ from the rear axle block Ⓑ.
3. Push the axle block Ⓑ upwards or downwards to the desired height (3 different positions:
steps from 15 mm).
4. Tighten the screws Ⓐ properly.
5. Mount the rear wheels.
6. Adjust the brakes according § 3.7.
Position 1
Shows the frame when the seat is horizontal and the
A
adapter is perpendicular to the ground.
B Shows the frame when the seat is tilted slightly and the
adapter is not perpendicular.
Position 2
It is also possible to rotate the rear axle block Ⓑ (2
positions: steps from 15 mm).
Page 14
Eclips X4 kids 90°
2014-08
Position 3