Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DESCRIPTION OF THE DEVICE
(1) Washlight with RGB+UV LEDs
(2) Strobe ring with cold white LEDs
(3) Derby with RGBAW+UV LEDs
(4) Infrared sensor for the remote control
(5) Laser output aperture
(6) Mounting brackets
(7) Housing
(8) Display with operations buttons
(9) USB port for QuickDMX receiver
INSTALLATION
WARNING! Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure
that the device is installed securely and cannot fall down. The installation must be carried out by
a specialist who is familiar with the hazards and the relevant regulations.
DANGER! Damage caused by laser radiation
Observe the chapter safety instructions when installing the device.
The device may be placed on the floor or fastened to a truss or similar rigging structure. The device must
never be fixed swinging freely in the room.
1
The rigging structure must support at least 10 times the weight of all fixtures to be installed on it.
2
Block access below the work area and work from a stable platform when installing the device.
3
Use rigging hardware that is compatible with the structure and capable of bearing the weight of the
device. Please refer to the "Accessories" section for a list of suitable rigging hardware.
4
Secure the device with a safety bond or other secondary attachment. This secondary safety attachment
must be sufficiently dimensioned in accordance with the latest industrial safety regulations and
constructed in a way that no part of the installation can fall down if the main attachment fails. Pull the
safety bond through the safety eyelet and fasten it in such a way that, in the event of a fall, the maximum
drop distance of the device will not exceed 20 cm.
(10) Fixation screws
(11) DMX input
(12) DMX output
(13) Microphone
(14) Safety eyelet
(15) Power feed-through output
(16) Fuse holder
(17) Power input
21/32
00116304, Version 1.0
Werbung
Inhaltsverzeichnis
